Internet, Networking, & Security Home Networking How IP Network Routing Works Your data makes a lot of stops before reaching its final destination Share Pin Email Print Yagi Studio Home Networking ISP The Wireless Connection Routers & Firewalls Network Hubs Broadband Ethernet Installing & Upgrading Wi-Fi & Wireless By Nadeem Unuth Freelance Contributor Nadeem Unuth is a former freelance contributor to Lifewire who specializes in information and communication technology with a focus on VoIP. our editorial process LinkedIn Nadeem Unuth Updated July 10, 2019 88 88 people found this article helpful Routing is the process by which data packets move from one node (machine or device) to another on a computer network until they reach their final destination. Understanding Network Routing You can think of the way data is routed as similar to how you might get to a far-off place in your city using a series of bus trips. The entire bus system, including all the stops, is like the network, and the stops themselves are like the nodes. As a bus rider who must make several transfers to get where you're going, you're like the data that travels between each node until it reaches its final destination. When data is transferred from one device to another on an Internet Protocol (IP) network, it's is broken down into smaller units called packets. In addition to the actual data, each packet includes a header that contains information to help it get to its destination, similar to the physical address information you might find on a mailed envelope. But, instead of physical addresses, the header information includes: The IP addresses of the source and destination nodesPacket numbers that help reassemble the packets in the correct order when they reach their destinationOther useful technical information How Routing Works Consider a scenario in which Li sends an email message from his computer in China to Jo's machine in New York. Transmission Control Protocol (TCP) and other protocols do their work with the data on Li's machine, then it's sent to the IP module, where the data packets are bundled into IP packets and sent over the network. To reach their destination on the other side of the world, the data packets must pass through many routers. The work these routers do is called routing. The IP and TCP protocols work together to ensure transmissions are reliable, meaning that no data packets are lost, that they're in order, and that there's no unreasonable transmission delay. In some services, TCP is replaced with Unified Datagram Packet (UDP) which doesn't ensure reliability, but rather just sends packets over. Some Voice over Internet Protocol (VoIP) systems use UDP for calls because lost packets don't affect call quality much. Each of the intermediate routers "reads" the destination IP address of each received packet. Based on this information, the router sends the packets in the appropriate direction. Each router has a routing table where information about neighboring routers (nodes) is stored. This information includes the cost (in terms of network requirements and resources) of forwarding a packet in the direction of that neighboring node. Information from this table is used to decide the most efficient node to use or the best route on which to send the data packets. Each packet can be sent in a different direction, but they eventually all get routed to the same destination machine. On reaching Jo's machine, the packets are consumed by the machine, where the IP module reassembles them and sends the resulting data to the TCP service for further processing.