How to Clean a Clear Phone Case

Have a clear case, but let it get dirty? Not to worry, cleaning is it easy

What to Know

  • First, with some mild soap and some warm water, thoroughly scrub your case with a brush. Be careful with any cracks or peeling portions.
  • If the case is still dirty, with a soft (preferably microfiber) cloth, scrub it with isopropyl alcohol to remove stains and yellowing.
  • Lower-strength alcohol will be less abrasive but also a less effective cleaner. Not all cases will react well with alcohol, though.

This article explains how to clean a clear phone case. Depending on your case, you may not need anything more than soap and water, but you may need to pick up a brush, microfiber cloth, and some isopropyl alcohol if you need to get some heavy-duty cleaning done.

You can best clean most cases with alcohol, but it may cause damage to some. Before cleaning, it's best to search online to see how to clean your case's material and how others have fared using alcohol-based cleaners.

How Can I Make My Phone Case Clear Again?

Before you get to cleaning, make sure to brush off any dirt or debris from your case as well as tear off any frayed or peeling bits that might rip out larger sections of your case during cleaning, if applicable.

  1. Get to the sink, and run the water until it's warm to the touch. You don't need it to be a specific temperature, and a little more on the warmer side is entirely okay.

  2. Rinse off your case thoroughly, and with a brush or a sponge, do your best to wipe away any visible patches of dirt or grime.

  3. With a hearty dollop of soap, give your case a full-body scrub-down. Don't feel like you have to be too gentle, but be careful not to snap, tear, or crack your case, depending on the material.

  4. Rinse off all the soap, and dry your case thoroughly. If you're happy with its cleanliness, you're done; if not, it's time for the alcohol.

  5. Wet a microfiber cloth with a bit of your isopropyl alcohol, and give your case a full-body wipedown. Then, focus your efforts on any stains or yellow areas with rigorous scrubbing, reapplying alcohol to the cloth as needed.

    You can use any strength isopropyl alcohol, which is a helpful cleaning product for a wide variety of electronics. Still, as a rule, lower-strength alcohol will clean less efficiently and require more scrubbing than higher-strength alcohol. However, higher-strength alcohol is more abrasive and can peel or discolor or even crack certain materials.

  6. Repeat this process until you're satisfied. If you start to notice any chipping, cracking, tearing, or anything that would indicate you're too rough with your case, stop.

Was this page helpful?