Home Theater & Entertainment Audio 149 149 people found this article helpful What Is a Speaker Efficiency Rating? When it comes to your speakers, volume has little to do with power. by Gary Altunian Writer Gary Altunian was a freelance contributor to Lifewire and industry veteran in consumer electronics. He passion was home audio and theater systems. our editorial process Gary Altunian Updated on December 11, 2019 Kirby Hamilton / Getty Images Audio Speakers Stereos & Receivers Tweet Share Email Amplifier power is a misunderstood concept. Many people mistake a speaker amp's power rating or wattage for its loudness. Doubling the power output of a speaker will not double the speaker's maximum volume. There are two ways in which an amp's power rating is relevant: The efficiency of a speakerThe ability of the amplifier to handle volume peaks What Is Speaker Efficiency? Speaker efficiency, also known as speaker sensitivity, is a measure of a speaker's decibel output at a specified amount of amplifier power. For example, a speaker's efficiency is typically measured with a microphone placed one meter from the speaker. As one watt of power is delivered to the speaker, the microphone measures the resulting volume though a decibel level meter. The output level that results is the speaker's efficiency rating. Speakers range in efficiency or sensitivity from about 85dB (very inefficient) up to 105dB (very efficient). To compare, a speaker with an 85 dB efficiency rating will take twice the amplifier power to reach the same volume as a speaker with 88 dB efficiency. Similarly, a speaker with an 88 dB efficiency rating will require ten times more power than a speaker with a 98 dB efficiency rating to play at the same volume. If you're starting with a 100 watt/channel receiver, you would need 1000 watts (!) of power to double the perceived volume level. Dynamic Range Music is dynamic in nature. It's always changing in tone and volume, with tone measured by frequency and volume measured by amplitude or perceived loudness. The best way to understand audio dynamics is to listen to live, non-amplified music. An orchestra, for example, has a wide range of volume levels, from very quiet passages to loud crescendos and some in-between. This range in volume is known as dynamic range, the difference between the softest and loudest passages. When the same music is reproduced through an audio system, the system should reproduce or approximate the same loudness range. When played back at an average volume level, the soft and medium passages in the music would require minimal power. If the receiver had 100 watts of power per channel, the soft and medium passages would require roughly 10-15 watts of power. However, the crescendos in the music would require significantly more power for short periods of time, perhaps as much as 80 watts. A cymbal crash is another good example of the difference between dynamics and amplification. Although it is a brief sound, the cymbal crash demands a lot of power over a relatively short period of time. The ability of the receiver to deliver bursts of power in brief spurts is important for accurate sound reproduction. Although the receiver may only use a small portion of its maximum output most of the time, it must have the 'headroom' to deliver large amounts of power for short periods of time.