Purpose of and 192.168.1.x IP Addresses

Many home computer networks use these IP addresses

The IP addresses,, and are part of an IP address range typically used on home computer networks. These IP addresses are commonly found in homes using broadband routers, but the same addresses can be used with other home routers and other kinds of private networks.

Lifewire / Tim Liedtke 

How Home Routers Use the 192.168.1.X IP Address Range

Home routers by default define a range of IP addresses to be assigned to client devices through Dynamic Host Configuration Protocol. Routers that use as the network gateway address typically assign DHCP addresses starting with—so will be the second such address in line to be assigned, the third, the fourth, and so on. While DHCP does not require addresses to be assigned in sequential order like this, it is the normal behavior.

In most homes, the router acts as a DHCP server that issues unique IP addresses to devices on the network.

Assigned addresses can be swapped over time. For example, in a Wi-Fi home network, when a game console and phone are disconnected from the network for an extended period, their addresses return to the DHCP pool. These addresses may be reassigned to a new device that connects to the network. If the phone and game console later reconnect, they may or may not receive the same IP address they had previously. is a private (also called non-routable) IP address. It means computers on the internet or another remote network cannot communicate with that address without the assistance of intermediate routers. Messages from a home network router pertaining to refer to one of the local computers and not an outside device.

  1. The home network administrator uses a PC to set up the router and home network. The router assigns IP address to the PC.

  2. A second PC is added to the network. This PC receives the address.

  3. A game console then joins the network. It receives as its address.

  4. A phone connects to the router using Wi-Fi, receiving as its network address.

Configure the 192.168.1.x IP Address Range

Any home network or another private network can use the 192.168.1.x IP address range even if the router uses different settings by default. To set up a router for this specific range:

  1. Log in to the router as an administrator.

  2. Find the router's IP and DHCP settings. The location of these can vary depending on the router, but they are often in a Setup menu.

  3. Set the router's local IP address to or another address in the 192.168.1.x range. The number used in place of x should be a low number to allow address space for additional clients that might join the network.

  4. Set the DHCP starting IP address to 192.168.1.x+1. For example, if the router's IP address is, then the starting IP address for clients can be

Was this page helpful?